1.Resetting to version 4.8
A reset to version 4.8 (downgrade) can only be performed with a USB memory on a HS4/FS4 or newer with firmware 4.9 or higher installed.
All data previously stored on the HS/FS and the project will be lost during downgrade.
After downgrading to 4.8, the HS/FS is assigned the IP address 192.168.0.11 and can be reprogrammed with the user "admin" and password "admin".
A downgrade can be performed as follows:
All data previously stored on the HS/FS and the project will be lost during downgrade.
After downgrading to 4.8, the HS/FS is assigned the IP address 192.168.0.11 and can be reprogrammed with the user "admin" and password "admin".
A downgrade can be performed as follows:
- Connect the prepared USB flash drive to the HS/FS.
- Restart the HS/FS.
- The HS/FS now boots from the USB flash drive and re-partitions the flash drive.
- Important: The HS/FS data are not backed up with this procedure!
- The HS/FS emits six beeps to signal that the process has finished.
- Switch off the device.
- Remove the USB memory.
- Restart the device.
- The downgrade is now complete.